TM 5-3820-276-10-1
OPERATOR MAINTENANCE
STARTING, OPERATION, AND SHUTDOWN PROCEDURES - WELDER/GENERATOR
INITIAL SETUP:
References
Equipment Condition (cont.)
Water Well Support Vehicle (WWSV) setup
Welder/Generator setup (WP 0044)
Equipment Condition
Water Well Support Vehicle (WWSV) grounded
WELDER/GENERATOR ENGINE STARTING PROCEDURE
WARNING
The Water Well Drilling System presents numerous falling hazards. Use care when
working on top of equipment. Failure to comply may result in injury or death to personnel.
Seek medical attention in the event of an injury.
CAUTION
Ensure equipment is disconnected from auxiliary power receptacles during startup and
shutdown. Some equipment can be adversely affected by changes in frequency as engine
rpm changes during startup and shutdown. Failure to comply may result in damage to
equipment.
NOTE
For additional description of welder/generator switches refer to (WP 0011).
1.
Set RUN/IDLE/IDLE LOCK switch (Figure 1, Item 2) to IDLE LOCK position.
0045-1
02/13/2013root(opusualwp)wpno(O20012)