TM 5-3825-270-23&P
0099
WIRE REPAIR - Continued
1
1
A
3
2
2
Figure 10. Splicing.
2.
Remove insulation (Figure 10, Item 2) from end of both wires (Figure 10, Item 1) equal to dimension A.
NOTE
Ensure all strands of wire are inside terminal when installing.
3.
Install butt connector (Figure 10, Item 3) over bare ends of wire (Figure 10, Item 1) and crimp.
4.
Inspect wire splice to ensure no bare wire is visible.
5.
Install two butt connectors (Figure 11, Item 5), one on each bare end of wire (Figure 11, Item 4).
4
5
6
4
5
A
7
7
Figure 11. Splicing With Added Wire.
6.
Crimp one end of both butt connectors (Figure 11, Item 5) securely over wire (Figure 11, Item 4).
7.
Measure distance between open ends of butt connectors (Figure 11, Item 5).
8.
Cut section of wire (Figure 11, Item 6) 1 in. (25 mm) longer than distance measured in Step 7.
9.
Remove insulation (Figure 11, Item 7) from both ends of wire (Figure 11, Item 6) equal to dimension A.
10.
Install bare ends of wire (Figure 11, Item 6) in butt connectors (Figure 11, Item 5) and crimp.
11.
Inspect splice to ensure no bare wire (Figure 11, Item 4), and (Figure 11, Item 6) is visible.
END OF TASK