TM 5-3825-270-23&P
0099
WIRE SOLDER REPAIR - Continued
NOTE
Ensure solder flows evenly on both ends of wire.
4.
Twist two ends of wire (Figure 13, Item 1) together and solder.
1
APPLY
SOLDER
2
1
Figure 13. Joint With Solder.
5.
Slide heatshrink tubing (Figure 13, Item 2) over solder joint.
WARNING
Never use open flame to apply heat to heatshrink tubing. Allow heatshrink tubing to cool prior
to handling. Failure to comply may result in injury or death to personnel.
CAUTION
Do not overheat tubing. Failure to comply may cause damage to wire.
NOTE
Ensure solder joint is centered in heatshrink tubing.
6.
Apply heat to heatshrink tubing (Figure 14, Item 2). Allow tubing to shrink until tight on solder joint and insulation
of wire (Figure 14, Item 1).
1
2
1
Figure 14. Joint With Solder and Heatshrink.
7.
Measure distance between ends of wire (Figure 15, Item 4).