TM 5-3825-270-23&P
0006
DECISION
No - Repair or replace orange/black wire between ENGINE START/ENGINE STOP switch and interconnect
terminal strip, terminal 6. (WP 0099) Verify problem is solved. (Step 16 - Does engine crank?)
Yes - Go to step 14. (Step 14 - Are less than 200 ohms present on black wire between interconnect terminal
strip, terminal 6 and governor controller harness connector pin G2?)
STEP 14
Are less than 200 ohms present on black wire between interconnect terminal strip, terminal 6 and governor
controller harness connector pin G2?
1.
Disconnect governor controller harness connector. (WP 0092)
2.
Connect red multimeter lead to black wire at interconnect terminal strip, terminal 6.
INSIDE OF
15-AMP
CONTROL PANEL
CIRCUIT BREAKER
20
1
1
15
5
5
EMERGENCY
10
10
10
STOP SWITCH
5
15
15
1
20
20
INTERCONNECT
POSITIVE
NEGATIVE
TERMINAL STRIP
TERMINAL STRIP
TERMINAL STRIP
Figure 20. Interconnect Terminal Strip - Step 14.
3.
With the aid of an assistant, connect black multimeter lead to governor controller harness connector pin G2.
GOVERNOR
CONTROLLER
GOVERNOR
CONTROLLER
HARNESS
CONNECTOR
A
E
F
K
3
3
2
2
1
1
Figure 21. Governor Controller Harness Connector Pin G2 - Step 14.
4.
Note multimeter reading.