TM 5-3825-270-23&P
0006
3.
Note multimeter reading.
CONDITION/INDICATION
Are less than 200 ohms present on blue wire from governor controller harness connect pin A2 to starter relay?
DECISION
No - Repair or replace blue wire between governor controller harness connector pin A2 and starter relay.
(WP 0099) Verify problem is solved. (Step 16 - Does engine crank?)
Yes - Replace ENGINE START/ENGINE STOP switch. (WP 0208) Verify problem is solved. (Step 16 - Does
engine crank?)
STEP 16
Does engine crank?
1.
If disconnected, connect batteries. (WP 0085)
2.
Attempt to start engine. (TM 5-3825-270-10)
CONDITION/INDICATION
Does engine crank?
DECISION
No - If the problem still exists, it is possible that another fault exists or that another troubleshooting procedure
applies. If this was the first time through the task, restart the same symptom troubleshooting fault task.
Yes - Your original problem has been resolved.
END OF WORK PACKAGE
0006-18
