TM 5-3825-270-23&P
FIELD MAINTENANCE
GOVERNOR CONTROL MODULE REPLACEMENT
INITIAL SETUP:
Equipment Condition (cont.)
Tools and Special Tools
Batteries disconnected. (WP 0085)
Tool Kit, General Mechanic's: Automotive
Rear engine access cover removed. (TM
(WP 0225, Table 1, Item 12)
5-3825-270-10)
Materials/Parts
Locknut (WP 0226, Table 1, Item 58) Qty: 4
Lockwasher (WP 0226, Table 1, Item 37) Qty: 4
References
Parts Manual (WP 0220) Figure 4026
Equipment Condition
Engine OFF. (TM 5-3825-270-10)
REMOVAL
1.
Loosen screw (Figure 1, Item 2) and disconnect connector (Figure 1, Item 3) from governor control module
(Figure 1, Item 1).
1
3
2
Figure 1. Governor Control Module Removal.
2.
Remove four locknuts (Figure 2, Item 4), lockwashers (Figure 2, Item 5), washers (Figure 2, Item 6), screws
(Figure 2, Item 7) and governor control module (Figure 2, Item 1) from mounting surface (Figure 2, Item 8).
Discard locknuts and lockwashers.
