TM 5-3825-270-23&P
0006
5.
Release ENGINE START/ENGINE STOP switch.
CONDITION/INDICATION
Are 22 to 28 VDC present at starter relay blue wire with ENGINE START/ENGINE STOP switch in ENGINE
START position?
DECISION
No - Go to step 12. (Step 12 - Are less than 200 ohms present on red jumper wire from ENGINE START/ENGINE
STOP switch to ENGINE OFF/BATTERY DRAIN indicator?)
Yes - Go to step 11. (Step 11 - Are less than 200 ohms present on white wire from starter relay to starter
solenoid?)
STEP 11
Are less than 200 ohms present on white wire from starter relay to starter solenoid?
1.
Push in EMERGENCY STOP switch to off position. (TM 5-3825-270-10) (WP 0221)
2.
Disconnect batteries. (WP 0085)
3.
Set multimeter to measure continuity.
WARNING
Ensure electrical power is off prior to working on all electrical systems. Failure to comply
may result in injury or death to personnel.
Remove all jewelry, such as rings, ID tags, bracelets, etc., prior to working on or around
equipment. Jewelry and tools can catch on equipment, contact positive electrical circuits,
and cause a direct short, severe burns, or electrical shock. Failure to comply may result
in injury or death to personnel.
4.
Connect red multimeter lead to white wire at starter relay.
STARTER RELAY
WHITE WIRE
Figure 13. Starter Relay White Wire - Step 11.
5.
Connect black multimeter lead to white wire at starter solenoid.
