TM 5-3825-270-23&P
0029
INSIDE OF
15-AMP
CONTROL PANEL
CIRCUIT BREAKER
20
1
1
15
5
5
EMERGENCY
10
10
10
STOP SWITCH
5
15
15
1
20
20
INTERCONNECT
POSITIVE
NEGATIVE
TERMINAL STRIP
TERMINAL STRIP
TERMINAL STRIP
Figure 5. Positive Terminal Strip - Step 4.
8.
Note multimeter reading.
CONDITION/INDICATION
Are less than 200 ohms measured on red wire from BATTERY VOLTAGE gauge harness connector pin, 6 to
positive terminal strip, terminal 19?
DECISION
No - Replace red wire between BATTERY VOLTAGE gauge harness connector, pin 6 and positive terminal strip,
terminal 19. (WP 0099) Verify problem is solved. (Step 7 - Does BATTERY VOLTAGE gauge read normal?)
Yes - Go to step 5. (Step 5 - Are less than 200 ohms measured on black wire from BATTERY VOLTAGE gauge
harness connector, pin 5 to negative terminal strip, terminal 17?)
STEP 5
Are less than 200 ohms measured on black wire from BATTERY VOLTAGE gauge harness connector, pin 5
to negative terminal strip, terminal 17?
NOTE
This test is checking for high resistance within a wire. High resistance may cause gauge
readings to read inaccurately or abnormally.
1.
Connect red multimeter probe to BATTERY VOLTAGE gauge harness connector, pin 5.
