TM 10-4320-344-24
a.
Remove four cap screws (Figure 2-186,
1), lock washers (2), and flat washers
( 3 ).
Discard lock washers (2).
If a 3.0 inch (76.2 mm) cap screw is used mark location of screw.
b .
Remove two nuts (4), flat washers (5), machine screws (6), and forklift pocket
(7) from pumping assembly (8).
2.23.17.2 Repair.
a .
Inspect all components and mounting hardware for damage.
b .
Replace all defective
2.23.17.3 Installation.
If a 3.0 inch (76.2 mm)
components.
machine screw is used, install screw in location
marked in step 2.23.17.1 b.
a.
Position forklift pocket (7) on pumping assembly (8) and secure with two
machine screws (6), flat washers (5), and nuts (4) .
b .
Install four flat washers (3), new lock washers (2), and cap screws (1).
2-418
2.23.17 Forklift Pocket Maintenance, Model 609-C. (Continued)
