TM 10-4320-344-24
2.23.15 Shock Absorber Maintenance, Models 609-A and 609-C. (Continued)
Some shock absorbers may contain a locknut on lower mounting stud.
I f s o ,
remove and discard locknut.
a.
While holding lower shock absorber stud (Figure 2-184, 1) secure, remove lower
mounting nut (2), washer (3), and rubber bushing (4).
Some shock absorbers may contain a locknut on upper mounting stud.
I f s o,
remove and discard locknut.
b .
While holding upper shock absorber stud (5) secure, remove upper mounting nut
(6), washer (7), and rubber bushing (8).
c .
Compress shock absorber (9) and remove from upper mounting bracket (10) and
lower mounting bracket (11).
d.
Remove rubber bushing (12) from each end of shock absorber (9).
2.23.15.2 Repair.
a .
Inspect all components and mounting hardware for damage.
b .
Replace all defective components.
2.23.15.3 Installation.
a .
b .
c .
d.
e .
Install rubber bushing (12) on each end of shock absorber (9).
Compress shock absorber (9) and install lower stud (1) into lower mounting
bracket (11).
Extend shock absorber (9) and install upper stud (5) in upper mounting bracket
(10).
If locknut was present during removal procedures, install new locknut.
Install rubber bushing (8), washer (7), and while holding upper shock absorber
stud (5) secure, install upper mounting nut (6).
If locknut was present during removal procedures, install new locknut.
Install rubber bushing (4), washer (3), and while holding lower stud (1)
secure install lower mounting nut (2).
2-414