TM 10-4320-344-242.23.16 AxleMaintenance.This task covers:2.23.16.1 Removal2.23.16.4 Assembly2.23.16.2 Disassembly2.23.16.5 Installation2.23.16.3 RepairINITIALSETUPToolsEquipment Conditions (Continued)General Mechanic’s AutomotiveShock Absorbers removed, paragraphTool Kit, Appendix B, Section2.23.15 (609-A and 609-C).I I I,Item 1Motor Vehicle Maintenance Trestles,Appendix B, Section III, Item 2Do not work on equipment that is notsecurely stabilized to prevent rollingEquipment Conditionso r s l i d i n g.Pumping station shut down, TM 10-4320-Do not work on equipment that is not344-10.properly supported.Brake Lines removed, paragraph 2.23.6.Do not work on equipment without follow-ing standard shop safety practices.Wheel Cylinder, Brake Shoes, and BackingPlate removed, paragraph 2.23.9.This procedure applies to Model 609-A.The procedures for Models 609-C andUS636HCCD-1 are similar.2.23.16.1 Removal.To prevent injury to personnel, use caution when installing and removingtrestles beneath trailer assembly.Equipment slippage could result in deathor serious injury to personnel.a.Remove two front spring nuts (Figure 2-185,1) and mounting screws (2) fromfront hangers (3).b.Remove four rear spring nuts (4). mounting screws (5), and shackle plates (6)from two spring assemblies (7) and remove-2.23.16.2 Disassembly.a .Remove eight nuts (9), four U-bolts (10),spring assemblies (7) from axle (8).b .Remove eight nylon bushings (12) from twoc .Remove four2.23.16.3 Repair.a .Inspect allb.Replace allaxle assembly (8).two spring clamps (11), and twospring assemblies (7).nylon bushings (13) from two rear hangers (14).components and mounting hardware for damage.defective components.General Safety Instructions2-415
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
