TM 10-4320-344-24
Figure 2-189.
Install Protective Plywood Cap on Model 609-A.
Steel strapping has sharp edges.
To avoid personal injury, use care when
handling steel strapping.
(2) Secure plywood cap (1) to trailer chassis (2) with four strips of steel
strapping.
Route two strips over sides and two strips over ends.
Using
strapping seals and strapping sealer, tighten and seal the steel strapping.
2.25.2 Packing of Punping Assembly Model 609-C. Model 609-C does not require any packing
procedures to prepare it for movement.
2.25.3 Packing of Pumping Assembly Model US636HCCD-1.
Prepare Pumping Assembly US636HCCD-1
for movement as follows:
Tools
General Mechanic’s Tool Kit, Appendix B, Section III, Item 1
Sealer, steel strapping, hand, refer to TM 1 0 - 4 3 2 0 - 3 0 3 - 14
Personnel
Four personnel are required for installation of protective plywood cap.
2-421
