TM 5-3825-270-23&P
FIELD MAINTENANCE
PREPARATION FOR STORAGE OR SHIPMENT
INITIAL SETUP:
Not Applicable
PREPARATION FOR STORAGE INTRODUCTION
1.
The storage instructions apply to water distributors being taken out of service for a period of up to one year
with exercise. If water distributors are inactive for more than one year, they will use extended storage (water
distributor inactive) procedures within this file.
2.
Proper preservation of a water distributor and its individual parts for storage or shipment to a repair/rework
facility is vital to the life of that equipment.
3.
Instructions pertaining to security procedures are covered in TB 9-2300-422-20 (WP 0221).
END OF TASK
PREPARATION FOR STORAGE
NOTE
Prior to water distributor storage and shipment, perform the following.
1.
Perform all Field Preventive Maintenance Checks and Services (WP 0069) (PMCS).
2.
Correct all deficiencies noted during inspection if facilities are available. If repairs required are beyond the
scope of Field Maintenance, refer the deficiencies to Sustainment Maintenance.
3.
Place all Basic Issue Items (BII) into storage.
4.
Remove rust and corrosion, and scrape any flaked and peeling paint. Dry all surfaces to be painted and coat
with preservatives. Refer to TM 9-247 (WP 0221).
5.
Repaint surface, as required, to prevent against deterioration. Instructions pertaining to security procedures
are covered in TB 43-0209 (WP 0221).
END OF TASK
STORAGE
1.
Before placing a water distributor in storage, perform the following tasks:
a.
Fully drain water distributor. (TM 5-3825-270-10)
b.
Clean the engine, and frame. (TM 5-3825-270-10)
c.
Conduct a visual inspection of the water distributor. Check lubricant levels. Correct any discrepancies.
d.
Completely lubricate the water distributor and all ancillary equipment in accordance with
LO-5-3825-270-13 (WP 0221).
e.
Check the coolant level. Test the coolant to ensure that the cooling system is protected against corrosion
and temperatures down to -50F (-46C). Add antifreeze or corrosion inhibitors compatible with ethylene
glycol base antifreeze if cooling system is not adequately protected. Refer to TB 750-651 (WP 0221).
0217-1
