TM 5-3825-270-23&P
0040
STEP 2
Are less than 200 ohms measured from black/red wire on engine RESUME/IDLE switch to governor controller
harness connector, pin B1?
1.
Disconnect governor controller harness connector. (WP 0092)
2.
Ensure multimeter is set to measure continuity.
3.
Connect red multimeter probe to black/red wire on engine RESUME/IDLE switch.
BACK OF
RED/BLACK
PANEL
WIRE
ENGINE
RESUME/IDLE
SWITCH
RED
WIRE
BLACK/RED
WIRE
Figure 3. Engine Resume/Idle Switch - Step 2.
4.
With the aid of an assistant using jumper wire, connect black multimeter probe to governor controller harness
connector, pin B1.
GOVERNOR
CONTROLLER
GOVERNOR
CONTROLLER
HARNESS
CONNECTOR
A
E
F
K
3
3
2
2
1
1
Figure 4. Governor Controller Harness Connector - Step 2.
5.
Note multimeter reading.
CONDITION/INDICATION
Are less than 200 ohms measured from black/red wire on engine RESUME/IDLE switch to governor controller
harness connector, pin B1?