TM 5-3825-270-23&P
0040
DECISION
No - Go to step 5. (Step 5 - Are less than 200 ohms measured from black/red wire on engine RESUME/IDLE
switch to interconnect terminal strip, terminal 2?)
Yes - Go to step 3. (Step 3 - Are less than 200 ohms measured from red/black wire on engine RESUME/IDLE
switch to governor controller harness connector pin C3?)
STEP 3
Are less than 200 ohms measured from red/black wire on engine RESUME/IDLE switch to governor controller
harness connector pin C3?
1.
Ensure multimeter is set to measure continuity.
2.
Connect red multimeter probe to red/black wire on engine RESUME/IDLE switch.
BACK OF
RED/BLACK
PANEL
WIRE
ENGINE
RESUME/IDLE
SWITCH
RED
WIRE
BLACK/RED
WIRE
Figure 5. Engine Resume/Idle Switch - Step 3.
3.
With the aid of an assistant using jumper wire, connect black multimeter probe to governor controller harness
connector, pin C3.
GOVERNOR
CONTROLLER
GOVERNOR
CONTROLLER
HARNESS
CONNECTOR
A
E
F
K
3
3
2
2
1
1
Figure 6. Governor Controller Harness Connector - Step 3.
4.
Note multimeter reading.
