TM 5-3820-276-10-2
0202
Table 3.
PMCS - Welder/Generator - After Drilling Equipment Operation - Continued.
ITEM TO BE
EQUIPMENT
ITEM
CHECKED OR
NOT READY/
NO.
INTERVAL
SERVICED
PROCEDURE
AVAILABLE IF:
Check oil change indicator/maintenance display
Engine hours exceeded,
(Figure 6, Item 3) with engine off and engine control
oil change is due. Notify
switch (Figure 6, Item 1) in RUN position to observe
maintenance.
hours before next oil change.
2
3
4
1
WWDS00423
Figure 6.
Maintenance Display.
Fuel is below operating
2
After
Fuel Level
Check fuel level on fuel level indicator/maintenance
level.
Indicator/
display (Figure 6, Item 2), or fuel sight gauges (Figure
Maintenance
6, Item 4) on either side of unit. Add fuel as required
(Volume 1, WP 0043).
Display
3
After
Engine Oil Level
Check the engine oil level on the dipstick (Figure 7,
Engine oil is below or
Item 2). Add engine oil as required (WP 0210).
above indicator lines on
dipstick. If engine oil is
above top indicator line,
notify maintenance.
02/13/2013root(pmcswp)wpno(I20002)