TM 10-4630-207-13&P
UNIT MAINTENANCE
WASTE WATER VACUUM TANK TRAILER
NSN 4630-01-513-8155
HOSES
REPLACE
INITIAL SETUP:
Tools
Personnel Required
Tool Kit, General Mechanic's, Automotive (WP
MOS 77W, Water Treatment Specialist
Banding tool (WP 0053 00, Table 2, Item 1)
Materials/Parts
Equipment Condition
Gloves, Rubber (WP 0089 00, Table 2, Item 4)
Wastewater hoses steam cleaned
Gloves, Work (WP 0089 00, Table 2, Item 5)
Rags, Wiping (WP 0091 00, Item 28)
Respirator (WP 0089 00, Table 2, Item 8)
Seal, Strapping, -in (WP 0091 00, Item 29)
Strap, Steel Band -in (WP 0091 00, Item 31)
WARNING
Protective clothing and equipment must be worn. A heavy-duty rubber apron,
rubber gloves, respirator, safety splash goggles and/or face shield are
required when potential exists for contact with wastewater or contaminated
surfaces. Wastewater and surfaces may be contaminated with pathogenic
microorganisms, bacteria or viruses, which present a risk of serious illness or
death to personnel. Refer to cleaning and sanitizing procedures in WP 0018
REPLACE
To replace a 2-inch intake (figure 1, item 1), or 4-inch drain hose (figure 1, item 2), as well as a QD
fitting (figure 1, item 3), ensure item has been cleaned, sanitized and proceed as follows:
1. Cut banding (figure 1, item 4) from hose.
2. Remove coupling (figure 1, item 3) from hose.
0046 00-1
