TM 10-4630-207-13&P
0045 00
Brake lines
REPLACE
1. Actuator hose
a. Place an approved container under the master cylinder hose bracket (figure 41, item 1).
b. Loosen and remove hard line fitting (figure 41, item 2) from the brake hose (figure 41, item 3).
c.
Drain brake fluid from master cylinder into an approved container.
d. Loosen and remove cylinder hose bracket mounting bolts (figure 41, item 4) and lockwashers
(figure 41, item 5). Retain hardware.
e. Loosen and remove the brake hose from the orifice connector (figure 41, item 6) and discard in
an approved container.
f.
Connect new brake hose (figure 41, item 3) to orifice connector (figure 41, item 6).
g. Install master cylinder hose bracket (figure 41, item 1) with mounting bolts (figure 41, item 4) and
lockwashers (figure 41, item 5).
h. Fasten hard line fitting (figure 41, item 6) to the brake hose (figure 41, item 3).
i.
Bleed brake lines in accordance with brake filling and bleeding procedures within this Work
Package.
3
1
2
6
5
4
Figure 41. Actuator Brake Hose
0045 00-33
