TM 10-4630-207-13&P
0046 00
1
4
2
3
Figure 1. Hoses and Quick Disconnect Couplings
WARNING
Wear eye protection and gloves while banding. Banding may break if operator
does not release tension on handle when bending over buckle. Flying
banding may cause severe injury to personnel.
NOTE
Use the banding procedure described below as long as supplies of banding material are
available. Thereafter, use worm and drive hose clamps.
3. Insert serviceable coupling (figure 2, item 1) into hose (figure 2, item 2).
4. Band hose as follows.
a. Cut a 36-inch section of banding (figure 2, item 3).
b. Slide buckle onto banding (figure 2, item 3); bend end of banding (figure 2, item 3) under buckle
(figure 2, item 4).
c.
Wrap opposite end of banding (figure 2, item 3) around hose (figure 2, item 2) and through
buckle (figure 2, item 4). Position banding (figure 2, item 3) on hose approximately one inch from
coupling (figure 2, item 1).
0046 00-2
