TM 5-4320-300-146-11. CRANKSHAFT AND FLYWHEEL (CONT)Location/ItemActionRemarks57. FlywheelThread pilot studs into cylinder block. Guide housinghousinginto position against end plate by sliding housing overcrankshaft with an oil seal expander. Remove expanderand studs. Install mounting bolts and washers. Tightenbolts fingertight, beginning with No. 4 in sequence 1.Refer to sequence 2 and torque bolts No. 11 and 12 to19 to 23 ft lb (26 to 31 N.m) and bolts No. 7 through10 to 40 to 45 ft lb (54 to 61 N.m). Torque remainingbolts to 25 to 30 ft lb (34 to 41 N.m).WARNINGMake sure that hoists and other lifting equipment are in good repair and of sufficient capacity tosafely handle loads without injury to personnel or damage to equipment. Securely attach liftingequipment to flywheel. Before lifting, be sure load is balanced.58. FlywheelThread guide studs intoholes on crankshaft. Attachlifting bar with two3/8-16 bolts of suitablelength and lift flywheelinto position on crank-shaft and inside of fly-wheel housing. Supportflywheel and removelifting bar.6-111
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
