6-11. CRANKSHAFT AND FLYWHEEL (CONT)
Location/Item
Action
Remarks
CAUTION
Equipment damage through oil loss may occur if oil seals are damaged during installation.
51. Front oil
Coat lip of new oil seal
seal
lightly with MIL-G-10924
grease. Position seal in
engine lower front cover
with lip of seal pointed
toward inner face of cover.
Place engine lower front
cover in an arbor press
with the inner face down.
Press oil seal in until the
seal is flush with outside
face of cover. Remove ex-
cess sealant.
52. Rear oil
Support inner face of flywheel housing on
seal
a flat surface. If the new seal is not pre-
coated, apply MIL-S-45180 sealing com-
pound to the outside of metal casing.
Position seal with lip pointed toward inner
face of housing. Coat lip of oil seal lightly
with MIL-L-2104 oil. Press oil seal into
housing until seal is flush with outside of
housing. Remove excess sealant.
6-109
