TM 5-3825-270-23&P
FIELD MAINTENANCE
REAR ENGINE MOUNT BRACKET AND BUSHING REPLACEMENT
INITIAL SETUP:
Materials/Parts (cont.)
Tools and Special Tools
Lockwasher (WP 0226, Table 1, Item 43) Qty: 4
Tool Kit, General Mechanic's: Automotive
Isolation Mount (WP 0226, Table 1, Item 69)
(WP 0225, Table 1, Item 12)
Qty: 2
Jack, Hydraulic Hand Bottle Type, 20 Ton Cap
(WP 0225, Table 1, Item 2)
References
Parts Manual (WP 0220) Figure 4020
Materials/Parts
Parts Manual (WP 0220) Figure 4023
Lumber, Softwood, Dimension (WP 0224, Table 1,
Parts Manual (WP 0220) Figure 4024
Item 41)
Locknut (WP 0226, Table 1, Item 41) Qty: 4
Isolation Mount (WP 0226, Table 1, Item 49)
Equipment Condition
Qty: 1
Rear access panel removed. (TM 5-3825-270-10)
Lockwasher (WP 0226, Table 1, Item 55) Qty: 1
REMOVAL
WARNING
Engine assembly must be supported prior to removing mounting bracket hardware. Failure
to comply may result in injury or death to personal.
NOTE
Both rear engine mount brackets are removed the same way. Right side shown.
1.
Remove locknut (Figure 1, Item 2), upper snubbing washer (Figure 1, Item 1), upper isolator mount (Figure 1,
Item 6), screw (Figure 1, Item 3), and washer (Figure 1, Item 4) from engine mount bracket (Figure 1, Item 5)
and frame (Figure 1, Item 7). Discard locknut and isolator mount.
0135-1