TM 5-3825-270-23&P
0031
WHITE / BLACK
WIRE
RED
BACK OF
JUMPER
CONTROL
WIRE
PANEL
WHITE / RED
ENGINE OFF / BATTERY
WIRE
DRAIN INDICATOR
Figure 3. Engine Off/Battery Drain Indicator - Step 3.
4.
With the aid of an assistant using jumper wire, connect black multimeter lead to governor controller harness
connector, pin B3.
GOVERNOR
CONTROLLER
GOVERNOR
CONTROLLER
HARNESS
CONNECTOR
A
E
F
K
3
3
2
2
1
1
Figure 4. Governor Controller Harness Connector - Step 3.
5.
Note multimeter reading.
CONDITION/INDICATION
Are less than 200 ohms measured on white/red stripe wire from ENGINE OFF/BATTERY DRAIN indicator to
governor controller harness connector, pin B3?
DECISION
No - Go to step 4. (Step 4 - Are less than 200 ohms measured on white/red stripe wire on ENGINE OFF/
BATTERY DRAIN indicator to interconnect terminal strip, terminal 10?)
Yes - Repair or replace white/black stripe wire from interconnect terminal strip, terminal 9 to ENGINE OFF/
BATTERY DRAIN indicator. (WP 0099) Verify problem is solved. (Step 5 - Does ENGINE OFF/BATTERY DRAIN
indicator illuminate?)
STEP 4
Are less than 200 ohms measured on white/red stripe wire on ENGINE OFF/BATTERY DRAIN indicator to
interconnect terminal strip, terminal 10?
1.
Ensure multimeter is set to measure continuity.
