4-12. JUNCTION BOX MAINTENANCE

TM-10-4930-236-13P Tank and Pump Unit Liquid Dispensing; for Truck Mounting Mil Design Tank and Pump Unit Electric Motor Driven Model (97403) Manual
Page Navigation
60

TM 10-4930-236-13&P 4-12. JUNCTION BOX MAINTENANCE This task consists of: a. Test b. Repair c. Removal d. Installation INITIAL SETUP Tools Required General Mechanic Tool Kit (Appendix B, Section III, Item 3) Multimeter (Appendix B, Section III, item 11) Soldering Iron (Appendix B, Section III, Item 12) Materials/Parts Required Silicone Compound (Appendix E, Section II, Item 5) Solder (Appendix E, Section II, Item 3) Heat Shrink Insulation (Appendix E, Section II, Item 10) O-Ring Packing (1) (Appendix F) Lockwashers (Appendix F) Equipment Condition Pumping Unit Shutdown General Safety Instructions WARNING Low Voltage can cause injury or death. Silicone Compound is toxic to skin, eyes and respiratory tract. Avoid fumes Generated by soldering. TEST a. K1 Relay Test Procedure. (1) Place ON-OFF switch in OFF position. (2) Disconnect power cable from J2. (3) Unscrew and remove. cover (1) with O-ring packing (2) from junction box (3). 4-25

Privacy Statement
Press Release
Contact