TM 10-4930-236-13&Pb.Inspect nozzle body (5) and spout (1) for damage. Check free operation of lever (20).c.Inspect coupling half (6) for any damage. Check the gasket (7) and replace if damaged.d.Check grounding wires (12 and 14) for breaks, fraying and broken or missing covering. Make sure clip(13) jaws close firmly and inspect plug (11) and nut (10) for any damage. If clip (13) or wire (12) are defective,replace complete static discharger (8).NOTEDo not shorten grounding wire to less than 18 inches betweencontact and clip.e.If grounding wire (14) is broken or frayed at the contact (9) it may be repaired. Hold nut (19) andunscrew contact (9). Pull nut from wire (14) and cut off the frayed portion of the wire. Trim plastic cover fromthe end of wire and slide nut (19) over the end of wire (14), allowing approximately 1/4 inch of wire to extendthrough nut. Use a punch, or similar toot, to spread the end of wire (14) slightly, then screw contact (9) onto nut(19).f.If nut (10) was removed, use the same procedure as above to install it on wire (12).WARNINGCompressed air used for cleaning can create airborne particlesthat may enter the eyes. Pressure will not exceed 30 psig. Eyeprotection required.g.Use low pressure compressed air to dry strainer element (4) and remove any trapped particles.Replace the strainer element if there is damage to the screen.h.Replace any other parts that are damaged. Use a new O-ring packing (2) and gasket (3) at assembly.ASSEMBLYWARNINGSilicone compound, MIL-S-8660, is toxic to skin, eyes andrespiratory tract. Skin and eye protection required. Avoidrepeated or prolonged contact. Good general ventilation isnormally adequate.a.Apply silicone compound to O-ring packing (2) and install it on strainer element (4).b.Install strainer element (4) and gasket (3) on spout (1) and screw spout into nozzle body (5), handtight.c.Screw plug (11) onto nut (10) and install the static discharger (8) by screwing contact (9) into nozzlebody (5)d.Connect chain (15) and spring (16) to e-hooks (17) and squeeze the e-hook closed. Connect the s-hooks to the body (5) and cap (18) and squeeze closed. Install the cap (18) on spout (1).e.Apply sealing compound to threads of coupling half (6) and screw coupling half into body (5). Installgasket (7).4-21
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
