TM 10-4930-236-13&P
f.
Provide a suitable container beneath the filter/separator drain hose (8), open drain valve (9) and drain
fuel from filter/separator (10) and hoses (11, 12,13 and 14).
WARNING
Fuel spills create a potential fire hazard. Use a drip pan beneath hoses when
disconnecting.
g.
To remove any of hoses (11, 12 or 13), pull out on cam lock arms (15) and disconnect hose.
h.
To remove hoses (14 and 16), pull out on cam lock arms (17) to disconnect hoses at filter/separator
and manifold, then refer to paragraph 4-13 and remove the EMD Pump Assembly (18).
i.
Pull out on cam lock arms (19) and disconnect hoses (14 and 16).
j.
Remove any of the gaskets (20) that require replacement.
INSTALLATION
a.
Make sure each female coupling has a good gasket (20) installed.
b.
Connect hoses (14 and 16) to EMD Pump Assembly (18) and close cam lock arms (19). Refer to
paragraph 4-13 and install pump assembly.
c.
Connect hoses (14 and 16} at filter/separator and manifold and close cam lock arms (17).
d.
Install hoses (11, 12 and 13) and close cam lock arms (15).
WARNING
A spring loaded mechanism can cause injury if released in an uncontrolled
manner. The rewind spring is under high tension when the dispensing hose is
extended. This may cause reel to rapidly rotate in reverse.
e.
Connect reel hoses (2) and close cam lock arms (6). Install lockwire (5) and wind hose onto reel.
f.
Connect nozzle (3) to hose (2) and close cam lock arms (7).
g.
Make sure that drain valve (9) is closed.
4-16
