TM 10-4930-236-13&P
4-9. STATIC DISCHARGE REEL MAINTENANCE
This task consists of:
a.
Removal
b.
Installation
INITIAL SETUP
Tools Required
General Mechanic Tool Kit (Appendix 8, Section III, Item 3)
Torque wrench (Appendix B, Section III, Item 2)
Materials/Parts Required
Lockwasher (2) (Appendix F)
General Safety instructions
WARNING
Spring loaded mechanisms can cause injury.
REMOVAL
WARNING
A spring loaded mechanism can cause injury if released in an uncontrolled
manner. The rewind spring is under high tension when the dispensing hose is
extended. This may cause reel to rapidly rotate in reverse.
NOTE
Discard mandatory replacement parts.
a.
Remove nuts (1), lockwashers (2), screws (3) and flat washers (4).
b.
Remove static discharge reel assembly (5) from frame (6).
INSTALLATION
a.
Position static reel assembly (5) on frame (6) and aline mounting holes.
b.
Install screws (3), flat washers (4), lockwashers (2) and nuts (1). Torque to 50 - 55 ft.-lbs. (67.8 -
74.6 Nm).
c.
Pull cable (7) all the way out and check to see that it rewinds fully. onto static discharge reel (5).
4-18
