Figure 4-12. Magneto, Removal and Installation.

Figure 4-11. Ignition Cable, Spark Plug, Ground Cable and Ignition Switch, Removal and Installation.

Figure 4-13. Magneto Points Replacement.

TM-10-4930-204-13 Tank and Pump Unit Liquid Dispensing for Truck Mounting (United Manufacturing and Engineering Corp. Model Style 1) Manual
Page Navigation
75

TM 10-4930-204-13 Figure 4-12. Magneto, Removal and Installation. (2) Cleaning and inspection. Drycleaning solvent normally has a flash point of either 100 or 138 degrees F, depending on the type being used, but may flash at much lower tem- peratures if contaminated with gasoline or jet fuel . Avoid repeated and prolonged skin contact. Do not use near open flame or excessive heat. (a) Clean all parts with a cloth dampened with drycleaning solvent (item 1, App. F), and dry thoroughly. (b) Inspect all parts for cracks, breaks and other damage. Replace defective parts. (c) Inspect mounting hardware for damaged threads. Replace damaged or missing hardware. (3) Magneto breaker points replacement. Refer to figure 4-13 and replace magneto points. (4) and remove and Magneto drive gear replacement. Refer to figure 4-14 install magneto drive gear. 4-33

Privacy Statement
Press Release
Contact