Figure 4-9. Starter Pulley, Air Shroud, and Ignition Switch Bracket, Removal and Installation.

Figure 4-10. Flywheel, Removal and Installation.

TM-10-4930-204-13 Tank and Pump Unit Liquid Dispensing for Truck Mounting (United Manufacturing and Engineering Corp. Model Style 1) Manual
Page Navigation
71

TM 10-4930-204-13 Figure 4-9. Starter Pulley, Air Shroud, and Ignition Switch Bracket, Removal and Installation. c. Air Shroud. (1) Removal. (a) Remove (b) Remove starter pulley (para 4-24b.). three bolts and ignition switch and bracket from top of air shroud (fig. 4-9). (c) Remove two bolts that secure air shroud to engine base; remove shroud. (2) Cleaning and inspection. Drycleaning solvent normally has a flash point of either 100 or 138 degrees F, depending on the type being used, but may flash at much lower tem- peratures if contaminated with gasoline or jet fuel . Avoid repeated and prolonged skin contact. Do not use near open flame or excessive heat. 4-29

Privacy Statement
Press Release
Contact