TM 10-4930-204-134-24. ENGINE.a. General. The following paragraphs contain the organizational maintenance instructions necessary for variouscomponents associated with the engine.b. StarterPulley.(1) Removal. Loosen pulley hub with suitable wrench and turn pulley counterclockwise to remove (fig. 4-9).(2) Cleaningandinspection.WARNING(a)(b)Drycleaning solvent normally has a flash point of either 100 or138 degrees F, depending on the type being used, but mayflash at much lower temperatures if contaminated with gasolineor jet fuel. Avoid repeated and prolonged skin contact. Do notuse near open flame or excessive heat.Clean all parts with drycleaning solvent (item 1, App. F), and dry thoroughly.Inspect all parts for cracks, breaks, damaged threads, and other defects. Replace a damaged part.(3) Installation.Position starter pulley and turn clockwise to install (fig. 4-9). Secure pulley by tightening hubwith a suitable wrench.Change 4 4-28.1/(4-28.2 Blank)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
