TM 10-4930-204-13(a) Clean all parts with drycleaning solvent (item 1,App. F) and dry thoroughly.(b) Inspect all parts for cracks, breaks, and otherdamage.Replace defective parts.(c)Inspect all threaded parts for damaged threads.Replace defective parts.(d) Replace gasket.(3) Installation.(a)Install mounting bracket and straps and securewith through bolt.(b) Install fuel strainer body in tank.(c)Insert fuel shutoff valve, and elbow into body.(d) Install screen, gasket and bowl and tighten fuelstrainer bail nut.(e) Install fuel tank and secure with upper fuel tankmounting bracket/cylinder head bolt, and two lower fuel tank mountingbracket retaining bolts.(f) Connect fuel line to elbow and refill fuel tank asnecessary.h.AirCleanerandBracket.(1) Removal.Remove screws that secure air cleaner andbracket to engine and remove air cleaner and bracket (fig. 4-17).(2) Cleaning andinspection.Drycleaning solvent normally has a flash pointof either 100 or 138 degrees F, depending on thetype being used, but may flash at much lower tem-peratures if contaminated with gasoline or jetfuel .Avoid repeated and prolonged skin contact.Do not use near open flame or excessive heat.(a) Clean all parts with drycleaning solvent, (item 1,App. F), and dry thoroughly.(b) Inspect all parts for cracks, breaks, and otherdamage.Replace defective parts.4-37
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
