Figure 4-20. Governor Controls, Removal and Installation.

Figure 4-21. Governor Controls Adjustment.

TM-10-4930-204-13 Tank and Pump Unit Liquid Dispensing for Truck Mounting (United Manufacturing and Engineering Corp. Model Style 1) Manual
Page Navigation
84

TM 10-4930-204-13 (e) Remove screw and speed control bracket from engine. (2) Cleaning and inspection. Drycleaning solvent normally has a flash point of either 100 or 138 degrees F, depending on the type being used, but may flash at much lower tem- peratures if contaminated with gasoline or jet fuel. Avoid repeated and prolonged skin contact. Do not use near open flame or excessive heat. (a) Clean all parts with drycleaning solvent (item 1, App . F), and dry thoroughly. (b) Inspect all parts for cracks, breaks, and other damage. Replace defective parts. (c) Inspect mounting hardware for damaged threads. Replace damaged or missing parts. (3) Installation. (a) Refer to figure 4-20 and mount speed control bracket on engine and secure with screw. Figure 4-20. Governor Controls, Removal and Installation. 4-42

Privacy Statement
Press Release
Contact