TM 10-4930-204-13
(b) Remove the air shroud and ignition bracket (para
4-24c.).
(c) Remove fuel tank retaining bolt, cylinder head
bolts, cylinder head, and gasket (fig. 4-23).
Figure 4-23.
Cylinder Head, Removal and Installation.
(2) Cleaning and inspection.
Drycleaning solvent normally has a flash point
of either 100 or 138 degrees F, depending-on the
type being used, but may flash at much lower tem-
peratures if contaminated with gasoline or jet
fuel.
Avoid repeated and prolonged skin contact.
Do not use near open flame or excessive heat.
(a) Clean all parts with drycleaning solvent (item 1,
App. F), and dry thoroughly.
4-46