3.6.2 Intermediate Bracket Assembly Replacement.

Figure 3-3. Intermediate Bracket Assembly Replacement.

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
448

TM 10-4320-344-24 3.6.2 Intermediate Bracket Assembly Replacement. This task covers: 3.6.2.1 Removal 3 .6 . 2 . 2 I n s t a l l a t i o n INITIAL SETUP Tools Equipment Conditions General Mechanic’s Automotive Pumping Tool Kit, Appendix B, S e c t i o n I I I , 1 0 . Item 1 Pumping Hoist, Lifting Sling, Appendix B, Section III, Item 2 General station shut down, TM 10-4320-344- Assembly removed, paragraph 3.6.1. Safety Instructions Materials/Parts Do not work on equipment that is not securely stabilized to prevent rolling or Lock Washers (US636HCCD-1 only, s l i d i n g. (TM 10-4320-344-24P) Gaskets (TM 10-4320-344-24P) Do not stand or put arms, legs, or any part of body under hoisted load. Personnel Do not work on equipment without following Two personnel are required to perform standard shop safety precautions. this procedure. This procedure The procedures applies to for Models the intermediate bracket assembly for Model 609-C. 609-A and US636HCCD-1 are similar. 3.6.2.1 Removal. a. Remove twelve nuts (Figure 3-3, 1) and intermediate housing assembly (2) from pump casing assembly (3). b. Remove and discard gasket (4). 3.6.2.2 Installation. a. Place new gasket (4) over studs (5) on pump casing assembly (3). b . Install intermediate bracket assembly (2) on pump casing assembly (3) and secure with twelve nuts (1). 3-13

Privacy Statement
Press Release
Contact