Pump Assembly Replacement. (Continued)

Figure 3-2. S-Bolt Removal From Flywheel.

3.6.2 Intermediate Bracket Assembly Replacement.

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
447

TM 10-4320-344-24 3.6.1 Pump Assembly Replacement. (Continued) Do not stand or Failure to obey put arms, legs, or any other part of body under hoisted load. this warning may result in serious personal injury or death. The pump assembly is not equipped with a lifting device. Three personnel are required. When using chains or cables for lifting, position them so that the load will be balanced and pump assembly is not damaged. d. Using a suitable lifting t r a i l e r ( 6 ) . e. Align the splined end of device, raise pump assembly (5) and position it on impeller shaft (10) with bore of pilot bushing (13). Do not put stress on the castings or shaft. Damage to equipment may result. f . g . h. i . j . k. 1. Slide pump assembly (5) in place, seating impeller shaft (10) in pilot bushing (13) and pump drive-in drive coupling (16). Install twelve new lock washers (8) and bolts (7) securing to engine bellhousing (9). Align mounting holes of pump assembly (5) and trailer (6), d e v i c e: Do not tighten nuts. pump assembly (5) and lower lifting Install four mounting bolts (4), flat washers (3), new lock washers (2). and n u t s ( 1 ) . Do not tighten nuts (1). Make sure pump assembly (5) is level as necessary to attain level. Remove lifting device and sling from Tighten nuts (1). . . and aligned with engine. Add shims (12) pump assembly (5). 3-12

Privacy Statement
Press Release
Contact