TM 10-4320-344-24
2.14.4 Air Intake Assembly Maintenance, Model 609-C.
This task covers:
2.14.4.1 Removal
2 .
14 . 4 . 3 R e p a ir
2 .
14 . 4 . 2 I n s p e c t i on
2 .
14 . 4 . 4 I n s t a l l a t i o n
INITIAL SETUP
Tools
General Mechanics Automotive
Tool Kit, Appendix B, Section
III, Item 1
Material/Parts
Lock Washers (TM 10-4320-344-24P)
Equipment Conditions
Pumping station shut down, TM
10-4320-344-10.
Equipment Conditions (Continued)
Air Cleaner Assembly removed, paragraph
2 .
1
4 .
2 .
General Safety Instructions
To prevent rolling or sliding, do not work
on equipment that is not securely
s t a b i l i z e d .
Do not touch engine after shutting down
pumping assembly. Allow time for engine
t o c o o l.
Do not work on equipment without following
standard shop safety precautions.
2.14.4.1 Removal.
a.
Open left side engine access door (Figure 2-35,
1) on pumping assembly (2).
b.
Loosen hose clamp (3) and remove air intake hose (4) from intake adapter (5).
c .
Remove hose clamps (3 and 6) from air intake hose (4).
d.
Remove two nuts (7), lock washers (8), clamp (9), U-bolt (10), and intake
adapter (5) from turbocharger (11). Discard lock washers (8).
2.14.4.2 Inspection.
a.
Inspect air intake hose (4) and intake adapter (5) for cracks, holes, damage,
and corrosion of intake adapter (5).
b .
Inspect all mounting hardware for damage.
2.14.4.3 Repair.
Replace all defective components.
2.14.4.4 Installation.
a .
Install intake adapter (5) on turbocharger (11) and secure with U-bolt (10),
clamp (9), two new lock washers (8), and nuts (7).
b .
Install hose clamps (3 and 6) on air intake hose (4).
c .
Slide air intake hose (4) on intake adapter (5) and secure with hose
clamp (3).
2-102
