TM 10-4320-344-242.14.3 AirCleanerAssemblyMaintenance,ModelUS636HCCD-1.This task covers:2.14.3.1 Removal2 .14 . 3 . 5 R e p a ir2 .14 . 3 . 2 D i s a s s e m b ly2.14.3.6 Assembly2 .14 . 3 . 3 I n s p e c t i on2 .14 . 3 . 7 I n s t a l l a t i on2 .14 . 3 . 4 S e r v i ceINITIALSETUPToolsEquipment ConditionsGeneral Mechanic’s AutomotiveTool Kit, Appendix B, SectionIII, Item 1Goggles, Appendix B, Section III,Gun, Air Blow, Appendix B,Section III, Item 2Hose Assembly, Nonmetallic,Appendix B, Section III, Item 2Pumping station shut down, TM10-4320-344-10.General Safety InstructionsTo prevent rolling or sliding, do not workon equipment that is not securelys t a b i l i z e d.Don not use cleaning solvent withoutp r o p e r v e n t i l a t i o n o r c l o t h i n g , D o n otsmoke or use near open flame or excessiveheat.Material/PartsUse compressed air only with properGloves, Appendix C, Item 11personal protective equipment.Rags, Appendix C, Item 20Solvent, Dry Cleaning, Appendix C,Do not work on equipment without followingItem 26standard shop safety precautions.Lock Washers (TM 10-4320-344-24P)2.14.3.1 Removal.a.Loosen hose clamp (Figure 2-34, 1) and remove preformed hose (2) from airc l e a n e r ( 3 ).b .Remove two nuts (4) and bolts (5) from retaining clamps (6).c .Remove air cleaner (3) from retaining clamps (6).d .Remove four bolts (7), lock washers (8), and each retaining clamp (6). Discardlock washers (8).2.14.3.2 Disassembly.a .Remove wing nut (9) and cover (10) from air cleaner (3).b.Remove wing nut (11) and filter element (12).c .Remove hose clamp (13) and air cleaner intake cap (14).d.Remove knob (15) and vacuum diaphragm (16).2.14.3.3 Inspection.a .I n s p e c t a i r c l e a n e r ( 3 ) , c o v e r ( 1 0 ) , f i l t e r e l e m e n t ( 1 2 ) , a i r c l e a n e r i n t a kecap (14), knob (15), and vacuum diaphragm (16) for cracks, holes, and damage.b .Inspect all mounting hardware for damage.2-99
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
