2.14.3.5 Repair.
DO not use cleaning solvent without proper ventilation and clothing. Do not
smoke or use near open flame or excessive heat. Dry cleaning solvent is
potentially dangerous to personnel and property. Clean parts in a well.
ventilated area. Avoid inhalation of solvent fumes. Wear goggles and rubber
gloves to protect eyes and skin. Wash exposed skin throughly. Failure to obey
this warning may result in personal injury or death.
a.
Using cleaning rag dampened with cleaning solvent, wipe inside of ai cleaner
(3), air cleaner cover (10), and vacuum diaphragm (16).
b .
Replace all defective components.
2.14.3.6 Assembly.
a .
Install vacuum diaphragm (16) and knob (15) on air cleaner (3).
b .
Secure air cleaner intake cap (14) on air cleaner (3) with hose clamp (13).
c .
Install filter element (12) in air cleaner (3) and secure with wing nut (11).
d .
Position cover (10) on air cleaner (3) and secure with wing nut (9).
2.14.3.7 Installation.
Retaining clamps must face away from engine when installed.
a .
Position two retaining clamps (6) on mounting brackets and secure with four
new lock washers (8) and bolts (7).
DO not over tighten nuts on retaining clamps. Air cleaner body could be
damaged if nuts are too tight.
b .
Slide air cleaner (3) into two retaining clamps (6) and secure with two bolts
(5) and nuts (4).
c .
Slide preformed hose (2) on air cleaner (3) and secure with clamp (1).
2-101
TM 10-4320-344-24
NOTE
