TM 10-4320-315-24
2-31. MAINTENANCE OF MANUAL THROTTLE CONTROL CABLE
This task covers:
a.
Remove
b.
Install
INITIAL SETUP:
Tools
Equipment Conditions
General Mechanics Tool Kit
Pumping assembly is shutdown (refer to TM 10-4320-
(Item 1, Appendix B)
315-10).
Materials/Parts
Lockwashers (TM 10-4320-315-24P)
a. REMOVE. (Figure 2-19)
(1)
Open engine access door (1).
(2)
Loosen screw (2) from cable locking nut (3) and remove wire of cable (4) at fuel injection pump lever (5).
(3)
Remove nuts (6), lockwashers (7), bolts (8), and saddle clamp (9) that secure cable (4) to bracket (10).
(4)
Remove nut (11) and washer (12).
(5)
Remove cable assembly (4) by pulling away from panel.
b. INSTALL.
(1)
Install cable assembly (4) into cutout of panel. Secure with washer (12) and nut (11).
(2)
Position cable (4) on bracket (10) in engine compartment and secure with saddle clamp (9), bolts (8),
lockwashers (7), and nuts (6).
(3)
Install wire of cable (4) on fuel injection pump lever (5) with cable locking nut (3) and screw (2).
(4)
Close engine access door (1).
2-55
