TM 10-4320-315-24
2-33. MAINTENANCE OF COLD START AID HOSE, BOTTLE AND CABLE
This task covers:
a.
Remove
b.
Install
INITIAL SETUP:
Tools
Equipment Conditions
General Mechanics Tool Kit
Pumping assembly is shutdown (refer to TM 10-4320-
(Item 1, Appendix B)
315-10).
Materials/Parts
Tags (Item 21, Appendix C)
Lockwashers (TM 10-4320-315-24P)
a. REMOVE. (Figure 2-20)
(1)
Open air cleaner and engine access doors (1 and 2).
(2)
Loosen wing nut (3) on bottle clamp (4). Unscrew and remove ether bottle (5) from actuator (6).
(3)
Disconnect hose fitting (7) at actuator (6).
(4)
Disconnect hose fitting (8) at engine air intake line (9).
(5)
Remove hose assembly (10).
(6)
Loosen screw (11) at cable stop nut (12) on actuator lever (13). Loosen clamp (14) and remove wire end of
cable (15).
(7)
Remove nuts (16), lockwashers (17), flat washers (18), bolts (19), and bracket (20) with actuator (6).
(8)
Pull cable (15) through enclosure panel cutout hole (21) into engine compartment.
(9)
Loosen and remove all clamps from cable (15).
(10)
Loosen nut (22) and lockwasher (23) at handle (24).
(11)
Pull cable (10) through enclosure cutout at control panel.
b. INSTALL.
(1)
Install cable (15) through enclosure cutout at control panel.
(2)
Secure handle end of cable (15) to enclosure cutout with lockwasher (23) and nut (22).
(3)
Insert wire end of cable (15) through panel cutout hole (21) and into air cleaner compartment.
(4)
Install clamps on cable (15) in engine compartment.
2-57