TM 10-4320-315-24
2-31. MAINTENANCE OF AUTO DEFEAT CABLE
This task covers:
a.
Remove
b.
Install
INITIAL SETUP:
Tools
Equipment Conditions
General Mechanics Tool Kit
Pumping assembly is shutdown (refer to TM 10-4320-
(Item 1, Appendix B)
315-10).
a. REMOVE. (Figure 2-18)
(1)
Open engine access door (1).
(2)
Push handle (11) in and turn to lock.
(3)
Remove nut (2) and flat washer (3) from end of cable (4) at governor actuator lever (5).
(4)
Loosen nuts (6 and 7) at bracket (8) and pull cable (4) away from bracket.
(5)
Remove nuts (6 and 7) and washers (9).
(6)
Loosen setscrew (10) and remove handle (11) from cable (4).
(7)
Remove nut (12) and O-ring (13).
b. INSTALL.
(1)
Install O-ring (13) and nut (12) on cable (4).
(2)
Place cable (4) in engine compartment and install handle end of cable (4) into cutout of panel.
(3)
Install handle (11) on cable (4) and tighten setscrew (10).
(4)
Install washers (9) and nuts (6 and 7) on cable (4).
(5)
Position end of cable (4) in bracket (8) and tighten nuts (6 and 7).
(6)
Insert end of cable (4) in slot of governor actuator lever (5) and install flat washer (3) and nut (2).
(7)
Close engine access door (11).
2-53
