TM 10-4320-315-24
2-49. MAINTENANCE OF FUEL INJECTION LINES - (Cont)
(f) Tighten all fuel injection line nuts (1 and 3).
(g) Connect fuel leakoff lines to injectors with seal washers and banjo bolts.
(h) Install and latch air cowling.
(i) Bleed fuel system (para. 2-51).
(j) Remove drip pan.
(2) Install one fuel injection line that was removed singularly as follows (Figure 2-37):
(a) Feed fuel injection line (11) into its slot on the cowling mounting plate (10).
(b) Install grommet (9) on fuel injection line (11). Then push grommet (9) into its slot on cowling mounting
plate (10).
(c) Install each line clamp (8) on fuel injection lines with lockwasher (6), nut (7), and bolt (5).
(d) Connect but do not tighten fuel injection line nut (3) to fuel injector (4).
(e) Connect fuel injection line nut (1) at fitting of fuel injection pump (2).
(f) Tighten fuel injection line nuts (1 and 3).
(g) Connect fuel leak off line to injector with seal washers and banjo bolt.
(h) Install and latch air cowling.
(i) Bleed fuel system (para. 2-51).
(j) Remove drip pan.
2-95
