VALVES, CAMSHAFT, AND TIMING GEARS (CONT)

VALVES, CAMSHAFT, AND TIMING GEARS (CONT) - TM-5-4320-300-14_456

VALVES, CAMSHAFT, AND TIMING GEARS (CONT) - TM-5-4320-300-14_458

TM-5-4320-300-14 Pump Centrifugal Self-Priming Gasoline Engine Driven; 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Page Navigation
450

TM 5-4320-300-14 6-9. VALVES, CAMSHAFT, AND TIMING GEARS (CONT) Location/Item Action Remarks 49. Idler gear Place inner thrust inner thrust on forward end of washer idler gear hub with the inner diameter flat over the gear hub end flat, and with oil grooves in thrust washer facing the idler gear. 50. Hub Place protruding end of idler gear hub through the end plate, and into counter- bore in cylinder block. 51. Mounting Insert two 3/8-16 bolts bolt through hub as shown and thread them into the cylinder block. In- sert mounting bolt through center of hub and thread it into the cylinder block. Torque bolt to 40 to 45 ft lb (54 to 61 N.m). Then remove the two 3/8-16 bolts previously installed for alignment of hub. 52. Idler gear Lubricate hub and bearing with clean MIL-L-2104 oil. Position crankshaft gear so that the timing marks will align with those on the idler gear. Install idler gear with timing marks alined. 6-73

Privacy Statement
Press Release
Contact