REMOVAL - TM-5-4320-300-14

TM-5-4320-300-14 Pump Centrifugal Self-Priming Gasoline Engine Driven; 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Page Navigation
455

TM 5-4320-300-14 6-10. PISTONS AND CONNECTING RODS (CONT) Location/Item Action Remarks REMOVAL 1. Connecting Remove mounting nuts. rod bearing Remove each bearing cap caps and lower and lower bearing shell as bearing shells a unit. WARNING Severe burns, illness, or death may result if personnel fail to handle diesel fuel properly. Observe the following precautions: Do not inhale vapor. Work in a well-ventilated area. Do not use near open flame, sparks, or excessive heat. 2. Piston and Use VV-F-800 diesel fuel to soften carbon Upper bearing shells connecting deposits on upper inner surface of cylinder may not stay with rod assembly liner. Remove carbon deposits. Push piston connecting rods dur- and rod assembly out through top of cyl- ing piston and rod inder block. Reassemble bearing caps and removal. Ensure that lower bearing shells to the appropriate con- both upper and lower necting rods and upper bearing shells. bearing shells are accounted for after each piston and con- necting rod assembly is removed from the block. 6-78

Privacy Statement
Press Release
Contact