Section II. MAINTENANCE PROCEDURES - TM-5-4320-300-14

Direct Support Troubleshooting-Continued - TM-5-4320-300-14_301

TM-5-4320-300-14 Pump Centrifugal Self-Priming Gasoline Engine Driven; 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Page Navigation
295

TM 5-4320-300-14 Section II. MAINTENANCE PROCEDURES INDEX Para Para Air shutdown solenoid 5-8 Fuel tank and suction line 5-10 Alternator assembly 5-5 Impeller, shaft, seals, and Blower assembly 5-9 check valve 5-21 Cooling fan shaft bracket, shaft Main wiring harness 5-7 assembly, and pulley 5-17 Mechanical governor 5-15 Cylinder head and block 5-18 Overspeed governor 5-14 Engine assembly 5-16 Pump assembly 5-20 Exhaust heat shield 5-4 Starter motor assembly 5-6 Fuel control tube assembly 5-13 Suction and discharge gage valves, Fuel injectors 5-12 lines, hoses, and fittings 5-19 Fuel pump assembly 5-11 Trailer assembly 5-22 5-3. GENERAL INSTRUCTIONS Most maintenance instructions in this section will list resources required, personnel required, and equipment condition for the start of the procedure. Note the following: Resources required are not listed unless they apply to the procedure. Personnel required are listed only if the task requires more than one. If PERSONNEL is not listed, it means one person can do the task. The normal standard equipment condition to start a maintenance task is engine stopped and battery disconnect switch off. EQUIPMENT CONDITION is not listed unless some other condition is required besides the power being off. 5-6

Privacy Statement
Press Release
Contact