TM 5-3825-270-23&P
FIELD MAINTENANCE
ENGINE OIL COOLER AND HOSE REPLACEMENT
INITIAL SETUP:
References
Tools and Special Tools
Parts Manual (WP 0220) Figure 4044
Gloves, Rubber (WP 0225, Table 1, Item 2)
Tool Kit, General Mechanic's: Automotive
(WP 0225, Table 1, Item 12)
Equipment Condition
Goggles, Industrial (WP 0225, Table 1, Item 2)
Radiator drained. (WP 0075)
Wrench, Torque, 20-100 lb-ft (27-136 Nm), 3/8 in.
Oil filter removed. (WP 0123)
Drive (WP 0225, Table 1, Item 13)
Materials/Parts
Rag, Wiping (WP 0224, Table 1, Item 54)
Gasket, Oil Cooler (WP 0226, Table 1, Item 11)
Qty: 1
REMOVAL
WARNING
Cooling systems are hot and under pressure. Allow engine to completely cool prior to handling
any cooling system component or hose. Be sure to wear proper eye protection. Failure to
comply may result in injury or death to personnel.
1.
Remove fitting (Figure 1, Item 3) from engine oil cooler (Figure 1, Item 2) and engine block (Figure 1, Item 1).
1
2
3
Figure 1. Engine Oil Cooler and Hose Removal.
2.
Loosen two clamps (Figure 2, Item 5) and reposition to center of hose (Figure 2, Item 4).