TM 5-3825-270-23&P
0115
REMOVAL - Continued
3.
Remove fitting (Figure 1, Item 2) from thermostat housing (Figure 1, Item 3).
END OF TASK
INSTALLATION
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. Keep away from open fire and use in well-ventilated
area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately
with soap and water. Failure to comply may result in injury or death to personnel.
1.
Coat threads of fitting (Figure 2, Item 2) with pipe thread sealant.
1
2
3
8
4, 5, 6, 7
Figure 2. Engine Coolant Temperature Sending Unit Installation.
2.
Install fitting (Figure 2, Item 2) on thermostat housing (Figure 2, Item 3).
3.
Coat threads of engine coolant temperature sending unit (Figure 2, Item 1) with pipe thread sealant.
4.
Install engine coolant temperature sending unit (Figure 2, Item 1) in fitting (Figure 2, Item 2).
5.
Install wire (Figure 2, Item 8) on engine coolant temperature sending unit (Figure 2, Item 1) with fiber washer
(Figure 2, Item 7), washer (Figure 2, Item 6), lockwasher (Figure 2, Item 5), and nut (Figure 2, Item 4).
END OF TASK
FOLLOW-ON MAINTENANCE
1.
Fill coolant reservoir. (WP 0075)
