TM 5-3820-276-10-1
0028
DRILL BIT INSTALLATION - Continued
WARNING
Inner and outer table bushings can fall when table is in the open position. Ensure hands,
fingers, and feet are clear of bushings when opening table. Failure to comply may result in
injury or death to personnel. Seek medical attention in the event of an injury.
12.
Swing outer table (Figure 7, Item 6) to open position.
13.
Push main winch control lever (Figure 8, Item 3) forward to raise drill bit assembly (Figure 8, Item 5).
3
1
2
4
5
WWDS00671
Figure 8.
Sub Positioning.
14.
Install drill bit assembly (Figure 8, Item 5) in table (Figure 8, Item 4) until top of tooling joint (Figure 8, Item 2)
is approximately 0.5 in. (13 mm) above top of fork (Figure 8, Item 1).
15.
Close outer table (Figure 9, Item 6).