4-25. JET LEVEL SENSOR MAINTENANCE

TM-10-4930-236-13P Tank and Pump Unit Liquid Dispensing; for Truck Mounting Mil Design Tank and Pump Unit Electric Motor Driven Model (97403) Manual
Page Navigation
96

TM 10-4930-236-13&P 4-25. JET LEVEL SENSOR MAINTENANCE. This task covers: a. Removal b. Repair c. nstallation INITIAL SETUP : Tools Required General Mechanic Tool Kit (Appendix B, Section III, Item 3) Materials/Parts Required Dry Cleaning Solvent (Appendix E, Section II, Item 1) Sealing Compound (Appendix E, Section II, Item 6) Rags, Wiping (Appendix E, Section II, Item 13) Lockwashers (b) (Appendix F) Equipment Condition Pumping Unit Shutdown Tank 1/2 Full or Less General Safety Instructions WARNING Do not smoke within 50 feet (15.34 meters) of the Tank and Pump Unit. Dry cleaning solvent is potentially dangerous to personnel and property. REMOVAL a. Open manhole (1), remove capscrews (2) and lockwashers (3). b. Maneuver sensor (6) out for access, then disconnect sensor tubes (4). Note which tube is inlet and outlet. Clean tube and apply tape to prevent tube nuts (5) from falling back down tubes (4). Do not allow tubes (4) to fall into tank. c. Remove jet level sensor (6) from tank. d. Loosen hose clamp (7) and disconnect hose (8). e. Remove capscrews (9), lockwashers (10) and remove the jet level sensor (6) with deflector shield (11) from bracket (12). f. Remove screws (13) and flat washers (14) to release tray (15) from sensor (16). 4-61

Privacy Statement
Press Release
Contact