TM 10-4930-236-13&PREPAIRWARNINGDry cleaning solvent, P-D-680, used to clean parts is potentiallydangerous to personnel and property. Avoid repeated andprolonged skin contact. Do not use near open flame orexcessive heat. Flash point of solvent is 100 degrees F-138degrees F (38 degrees C-59 degrees C).a.Clean all metal parts with dry cleaning solvent and dry thorough 9.b.Inspect parts for damage and replace parts as required.c.Inspect fuel passage for obstructions.INSTALLATIONa.Install tray (15) on sensor (16) and install flat washers (14) and screws (13).b.Assemble deflector shield (11) to sensor (16) and position on bracket (12) with mounting holes alined.c.Install lockwashers (10) and capscrews (9)d.Connect hose (8) with clamp (7).e.While holding jet level sensor (6) in manhole(1), note the tube (4) marked inlet! then attach inlet tubeto jet level sensor inlet. Attach remaining tube (4).f.Position jet level sensor (6) within tank andsecure with capscrews (2) and lockwashers (3).g.Close and latch manhole (1).4-62
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
